Oase InScenio Notice D'emploi page 16

- EN -
Establishing a direct WLAN connection (access point mode)
The range of the WLAN connection between the InScenio EGC Controller Home/Cloud and your smartphone/tablet
can span a distance of up to 80 m provided there is unobstructed signal transmission and there is no source of interfer-
ence.
• Compatibility with the following WLAN standards: 802.11n+g+b
– Exclusively in the frequency range 2.4 GHz.
• The network name (SSID)
– The sequence of letters "xxxxxx" in the network name (SSID)
MAC address of the EGC controller.
• The standard password
– The EGC Controller is factory-set to the standard password
– The connection is encrypted and protected by a password.
The symbols used may differ slightly from the symbols on your smartphone/tablet.
iOS Android
16

is indicated on the label next to the type plate on the EGC Controller.

is also indicated on the label next to the type plate on the EGC Controller.
How to proceed:
1. Open "Settings".
2. Select and activate WLAN.
3. Select ʺOase EGC Controller xxxxxxʺ from the network list.
4. Enter the WiFi password and select "Connect".
– The connection to the EGC Controller is established.
– If the connection is successful, "Connected" (Android) or a "" (iOS) will appear
under the network name.
– Other WLAN connections are deactivated.
5. Start the "OASE Easy Control" app.
– The app automatically selects the language used by the operating system. If the
app does not support that language, it will use English.
– When establishing the connection to the EGC Controller for the first time, it is nec-
essary to define a device password to protect the EGC Controller from unauthor-
ised access.
– Remember the device password as it is also required for adding the InScenio EGC
Controller Cloud to the OASE cloud.

is device-specific and represents part of the

"oase1234".