Jabra Elite Sport Manuel D'instructions page 33

DECLARATIONS
The Bluetooth word mark and logos are owned by the Bluetooth SIG, Inc. and any use of such
®
marks by GN Netcom A/S is under license. Other trademarks and trade names are those of their
respective owners.
Wireless DECT standards vary depending on local legislation. Make sure that your product cor-
responds to the standard used in your country by ensuring that the product is purchased through a
local source of distribution.
For warranty information, please go to www.jabra.com.
FCC and IFETEL (wireless equipment):
This device complies with part 15 of the FCC rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
Users are not permitted to make changes or modify the device in any way. Changes or modifications
not expressly approved by GN Netcom, Inc. will void the user's authority to operate the equipment.
This device and its antenna must not be co-located or operating in conjunction with any other an-
tenna or transmitter. Non body-worn devices must be placed at least 8" (20cm) away from the body.
FCC (corded equipment):
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be deter-
mined by turning the equipment off and on, the user is encouraged to try to correct the interference
by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver
29