Publicité
Les langues disponibles
Les langues disponibles
Fitting bracket location
Fitting kit
- 1 fitting bracket
- 4 rubber inserts
- 1 ABS holder
- 2 threaded fasteners
Assembly
- Remove mirrors, the mat black front cover and the original windshield.
- Put the fitting bracket as indicated on the picture and place the 2 threaded fasteners on the bracket.
- Place the rubber seal as indicated on the photo.
- Place the ABS holder on the scooter and fit it on the bracket thanks to the 2 BHc 5x20 screws and
the 2 washers Ø5.
- Replace the mirrors : they finish fixing the support.
- Place the 4 rubber inserts and screw the windshield on its support using the remaining screws and
washers.
* Accessories gone up on the motorbike will not be any more considered as new and will be neither retaken nor exchanged.
* Ermax accessories are foreseen for original equipments. They will not be guaranteed if they are used in others conditions.
* Due to vehicles made tolerances, beyond our control, some Ermax products might need adjustings to fit.
* Aluminium screws are garanted until 6 Nm by our suppliers. Care to excessive clampings which may damage or break screws.
- 6 BHc 5×20 screws
- 6 plastic washers Ø5
- 1,35 m of rubber seal
« CAUTION »
FITTING INSTRUCTIONS
« WINDSHIELD »
GTS 125 EVO 2009 → ∞
Rubber seal location
Publicité
