Nahita blue 5173 Serie Mode D'emploi page 18

Unpacking and delivery inspection
Check that all of the items indicated below are included in the package, and that
nothing has been damaged:
- Balance
- Pan
- Instruction manual
- Power cable
- Calibration weight
In case the balance or any component presents any damage due to transport tell it
immediately to your transport agent or dealer so that they can make the claims in the
correct time limit.
Turning the balance on
1. Connect the balance to the power supply and press the power switch at the back
to its On position (-).
2. Press On/Off key; display will automatically light on and go through the below
sequence:
8.8.8.8.8.8.
Maximum capacity
------------
3. Finally the balance stays in a standby state of showing 0.000g in the display
Note: The initializing sequence depends on the stability of the load cell, thus, the
balance must not be located in an unstable surface or near wind blows. When the
indicator O flashes in the display, it means the environment is not good for the
following operations.
Warming up
Before performing calibration on the balance or measuring its accuracy it is necessary
to ensure that the balance is in a stable state.
For balance stabilization it is important that environmental temperature is stable.
Leave the balance on and in weighing mode for at least half an hour before
performing calibration; this is called "warming up".
Calibration
Perform balance calibration each time after moving it or in case there is obvious
tolerance error in weighing. Each balance includes the necessary weight for
calibration.
17