Auto Standby; Setting Up Clock; Setting Alarm - THOMSON DS500 Instructions D'utilisation

Power
CAUTION
• Risk of product damager! Make sure that the power voltage corresponds to the voltage printed
on the back label.
• Risk of electric shock! When you unplug the AC power cord always pull the plug from the socket.
Never pull the cord.
• Before connecting the AC power cord, ensure you have completed all other connections.
Place the unit in the desired position and unravel the mains cable. Insert the cable
into the supply socket and switch on if applicable.

Auto standby

When playing media from a connected device, the Tower automatically switches to
standby if:
• No button is pressed for 10 minutes,
• No audio from a connected device for 10 minutes.
Setting Clock
After the unit is plugged into a mains supply or mains power failure, the display will show the "0:00" on
the LCD display. The unit should be in standby mode to set the current clock.
1. Press MEM/TIME button, the digits for the display will blink.
2. Long press the
the hour setting.
3. The minute digits on the display will blink.
4. Press the / button repeatedly until correct minute is set. Press the MEM/TIME
minute setting.

Setting Alarm

This unit can be used as an alarm clock, The Bluetooth device, USB, FM is activated to play at a preset time.
1. Press to switch the unit to standby mode.
2. Make sure that you have set the clock correctly.
3. Press MEM/TIME
will display the last alarm record.
4. Press the MEM/TIME
5. Press / button repeatedly to set hour. Press MEM/TIME
6. Press / to set minute.
7. Press MEM/TIME
8. The volume would turn up from 0 to 25 gradually.
9. Press MEM/TIME
the display will blink.
10. Press the / to select OFF to cancel alarm.
/ button repeatedly until correct hour is set. Press the MEM/TIME
/ to select CD/FM status. Press MEM/TIME to
- EN 6 -