HIKVISION UD21782B Mode D'emploi page 8

Notes:

Water-proof treatment is required for cable connectors. Refer to Section 2.2 and 2.3 for details.

Tuck the connected cables into the cover to avoid squashing them.
4). Fit the main part of the device to the cover and tighten the screws.
4. Remove the protective sticker and protective film on the lens cover.
2.2 Installation of Network Cable Waterproof Jacket
2.3 Installation of Waterproof Tape
Figure 2-8 Secure the Device
Figure 2-9 Remove the Protective Sticker
7