Remotec BW0371 Mode D'emploi page 3

By Searching Through the Library
If you cannot identify a correct Device Code for your equipment from the Device
Code list, you may search the code through the library:-
1. Turn on your device manually (e.g. TV).
2. Press a desired Device Mode Key (e.g.
3. Hold down " P+ " and " VOL– " on the URC together simultaneously for 2
seconds until the indicator lights up.
4. Enter a corresponding Magic Search Code from following table. The in-
dicator should go out immediately.
DEVICE TYPE:
MAGIC SEARCH CODE: 0001 0005
(e.g. press device mode key, then press " P+ " and " VOL– " , and enter
TV
TV Magic Search Code 0001.)
5. Press the same desired device mode key again as in step 2 above. (e.g.
6. Hold down " P+ " & " VOL– " together simultaneously for 2 seconds until
the indicator lights up, and your URC is ready to start searching.
7. Aim the URC at your device (e.g. TV), press the "
and patiently until the device has been turned off.
Once your device has been turned off, immediately press " P+ " and
" VOL– " to lock in code and the indicator should go out.
* Simply repeat the above setup procedures to search the Device Code for
your DVD. (Remember to press a correct Device Mode Key and correct Magic
Search Code in step 2-5 above)
IMPORTANT:
– If the power on/off function of your device is not infra-red controlled - you
need to follow steps 2 to 6 above and start searching :-
• Press " " and another important function key alternately until your
device responds to the expected function, press " P+ " and " VOL– " to
lock in the code.
e.g. Press " " & " 1 " alternately, or ;
Press " " & "
Note:
– Each time you press the "
send out a POWER signal trying to turn off your device.
If you failed to stop pressing "
turned off, turn on your device again immediately. Before the indicator
goes out, press "
above and lock in code.
– If the indicator flashes twice after your pressing of "
already at the last code of the library. Press " P+ " and " VOL– " to resume
the URC and repeat carefully the above procedures to search again.
3 OPERATING THE URC
Normal Operation
Once you have set up the URC for your A/V equipment, it works like your origi-
nal remote controls. To operate, just aim it at your equipment, press an appro-
priate device mode key and invoke the desired function by pressing a corre-
sponding key on the URC. The indicator flashes during signal transmission and
as confirmation of key touch.
).
TV
TV DVD
" alternately.
", the URC will skip to the next code and
" in time when your device has been
" on the URC to skip backward. Repeat the step 7
2
English
)
TV
" key repeatedly, slowly
" key, you are