Publicité
Les langues disponibles
Les langues disponibles
Right hand Bracket
Fitting kit
- 4 fixing brackets
- 4 plastic washers Ø6
- 4 plastic washers Ø5
- 4 rubber spacers 5×5mm
- 1 central part
Assembly
- Fit fixing brackets as shown in photos (torque setting for engine cover screws is 1.2 kg/m2).
- Assemble the three sections of the Ermax belly pan using the four screws, plastic washers and the four
locknuts. The central part should be placed between the two others, inside the belly pan.
- Position the belly pan on the bike and fix it using the four 6x20 screws and the four 6mm plastic washers.
The rubber spacers should be inserted between the belly pan and the fixing brackets.
Re-position the oil and petrol overflow hoses / pipes
-
not be able to drip down inside the belly pan and ensure that they are
attached to the water overflow pipe with the cable tie.
* Offer up the belly pan to the bike when it is only partly assembled so that you
* Painted and varnished parts are not guaranteed against high pressure steam washes or aggressive cleaning products which can damage them and unstuck the varnish. We advise moreover, according to the technical data of our
painting suppliers, to wait one month to obtain a complete polymerization of varnish.
* Accessories gone up on the motorbike will not be any more considered as new and will be neither retaken nor exchanged.
* Ermax accessories are foreseen for original equipments. They will not be guaranteed if they are used in others conditions.
* Due to vehicules made tolerances, beyond our control, some Ermax products might need adjustings to fit.
* Belly pans will be neither retaken nor exchanged in case of rubbing during a "sports" driving, or during the clearing of pavements, uneven road surfaces ... The fitting of Ermax accessories is planned for a normal road use.
* Aluminium screws are garanted until 6 Nm by our suppliers. Care to excessive clampings which may damage or break screws.
can see exactly where the fixing points are located
FITTING INSTRUCTIONS
CB 600 HORNET 2007 → ∞
Insert steel washer between bracket & casing
- 4 screws BHc 6×20mm
- 4 screws BHc 5×15mm
- 4 locknuts Ø5
- 1 steel washer Ø6
- 1 plastic cable tie
ATTENTION
"BELLY PAN"
Left Hand Brackets
so that they will
Publicité
