Publicité
Les langues disponibles
Les langues disponibles
Photo1
Rubber spacers location
Fitting kit
- 4 rubber inserts
- 4 BHC 5×20 screws (small head)
- 2 fitting brackets
Assembly
- Place the rubber inserts on the fitting brackets.
- Fit them on the nose screen thanks to the BHC 5x20 screws and plastic washers, by inserting the
rubber spacers between the nose screen and the fitting bracket (see photo 1).
- Remove the 4 screws of the handlebar holder (see picture 2).
- Place the whole nose screen / fitting brackets on the handlebar holder and fit the unit by using the
provided BHc 8x40 screws.
* Accessories gone up on the motorbike will not be any more considered as new and will be neither retaken nor exchanged.
* Ermax accessories are foreseen for original equipments. They will not be guaranteed if they are used in others conditions.
* Due to vehicles made tolerances, beyond our control, some Ermax products might need adjustings to fit.
* Aluminium screws are garanted until 6 Nm by our suppliers. Care to excessive clampings which may damage or break screws.
Photo 2
Screws to remove and replace
- 4 Ø5 plastic washers
- 4 rubber spacers Ø5 L: 5mm
- 4 BHC 8×40 screws
« CAUTION »
FITTING INSTRUCTIONS
"NOSE SCREEN"
FZ8 N 2010 → ∞
Estimated fitting time : 15 mn
Publicité
