Ermax 8901087 Notice De Montage page 2

Rear right bracket
Rear left bracket
Assembly
- Position the 4 brackets as indicated on photos ( the torque wrench of the sump screws is 12 N.m
or 1,2 Kg/m²).
- Assemble the 2 parts of belly pan using the Ø 5×20 BHc screws, the washers and nuts furnished.
- Fix the belly pan on the brackets thanks to the Ø 6×15 BHc screws and the plastic washers
provided. Be careful not to tighten too much not to damage the part.
- Before tighten all the brackets and belly pan screws, check that the belly pan is clear of the
exhaust pipe. If it touches it, modify the bracket location.
* Painted and varnished parts are not guaranteed against high pressure steam washes or aggressive cleaning products which can damage them and unstuck the varnish. We advise moreover, according to the technical data
of our painting suppliers, to wait one month to obtain a complete polymerization of varnish.
* Accessories gone up on the motorbike will not be any more considered as new and will be neither retaken nor exchanged.
* Ermax accessories are foreseen for original equipments. They will not be guaranteed if they are used in others conditions.
* Due to vehicles made tolerances, beyond our control, some Ermax products might need adjustings to fit.
* Belly pans will be neither retaken nor exchanged in case of rubbing during a "sports" driving, or during the clearing of pavements, uneven road surfaces ... The fitting of Ermax accessories is planned for a normal road
use.
* Move hoses so that they do not fall inside the belly pans. Any deterioration due to flows of corrosive products is not guaranteed.
* Aluminium screws are garanted until 6 Nm by our suppliers. Care to excessive clampings which may damage or break screws.
Fitting kit
- 4 bracket
- 4 Ø6×15 BHc screws
- 4 Ø6 plastic washers
- 3 Ø5×20 BHc screws
- 3 M5 nuts
- 3 rondelles plastique Ø5
- 1 6×15 CHc screws
- 1 M6 nylock nuts
"ATTENTION
FITTING INSTRUCTIONS
« BELLY PAN »
CBF 500 2004/2007
Front right bracket
Front left bracket