Publicité
Les langues disponibles
Les langues disponibles
Fitting kit
- 2 washers (external Ø 25, internal Ø 10)
- 2 washers (external Ø 18, internal Ø 8)
- 4 rubber washers
- 3 M6 nuts
- 2 fixing brackets
Assembly
- Remove one engine/frame fixing bracket (triangular aluminium bracket).
- Insert one washer (ext Ø 30 - int Ø 10) between the bracket and the frame on the right screw; one
washer (ext Ø 17- int Ø 8) on the left higher screw; and the fixing bracket on the left lower screw (do not
completely tighten in order to be able to direct fixings thereafter).
- Follow the same procedure on the other side.
- Put one Ø 38 collar on the left frame, below the engine casing (see photos).
- Put one Ø 38 collar on the right frame, below the oil casing by fixing a M6×20 spacer with a M6×10
screw.
- Position the belly pan and fix it on its four fitting points (in front by two M6×10 screws and behind by
two M6×15 screws).
- Move the belly pan forwards and/or backwards to ensure that it is well clear of the exhaust pipes.
- Tighten the triangular aluminium bracket screws as well as the four belly pan screws.
* Painted and varnished parts are not guaranteed against high pressure steam washes or aggressive cleaning products which can damage them and unstuck the varnish. We advise moreover, according to the technical data of our
painting suppliers, to wait one month to obtain a complete polymerization of varnish.
* Accessories gone up on the motorbike will not be any more considered as new and will be neither retaken nor exchanged.
* Ermax accessories are foreseen for original equipments. They will not be guaranteed if they are used in others conditions.
* Due to vehicles made tolerances, beyond our control, some Ermax products might need adjustings to fit.
* Belly pans will be neither retaken nor exchanged in case of rubbing during a "sports" driving, or during the clearing of pavements, uneven road surfaces ... The fitting of Ermax accessories is planned for a normal road use.
* Move hoses so that they do not fall inside the belly pans. Any deterioration due to flows of corrosive products is not guaranteed.
* Aluminium screws are garanted until 6 Nm by our suppliers. Care to excessive clampings which may damage or break screws.
FITTING INSTRUCTIONS
XJR 1200 / XJR 1300 / SP 1999/2006
- 3 M6×10 screws
- 2 M6×15 screws
- 1 M6×20 spacers
- 2 Ø38 collars
« CAUTION »
"BELLY PAN"
Publicité
