Publicité
Les langues disponibles
Les langues disponibles
Right hand Bracket
Fitting kit
- 4 fixing brackets
- 4 plastic washers Ø6
- 4 plastic washers Ø5
- 4 rubber spacers 5×5mm
- 1 central part
Assembly
- Fit fixing brackets as shown in photos (torque setting for engine cover screws is 1.2 kg/m2).
- Assemble the three sections of the Ermax belly pan using the four screws, plastic washers and the four
locknuts. The central part should be placed between the two others, inside the belly pan.
- Position the belly pan on the bike and fix it using the four 6x20 screws and the four 6mm plastic washers.
The rubber spacers should be inserted between the belly pan and the fixing brackets.
-
Re-position the oil and petrol overflow hoses / pipes
be able to drip down inside the belly pan and ensure that they are attached
to the water overflow pipe with the cable tie.
Once fitted, the belly pan must have no contact with motor and has to be far
enough from complet exhaust system. Fitting brackets' angles may be a little
modified in order to adjust the accessory to every motorbike (do not fold the fixing
* Painted and varnished parts are not guaranteed against high pressure steam washes or aggressive cleaning products which can damage them and unstuck the varnish. We advise moreover, according to the technical data of our
painting suppliers, to wait one month to obtain a complete polymerization of varnish.
* Accessories gone up on the motorbike will not be any more considered as new and will be neither retaken nor exchanged.
* Ermax accessories are foreseen for original equipments. They will not be guaranteed if they are used in others conditions.
* Due to vehicles made tolerances, beyond our control, some Ermax products might need adjustings to fit.
* Belly pans will be neither retaken nor exchanged in case of rubbing during a "sports" driving, or during the clearing of pavements, uneven road surfaces ... The fitting of Ermax accessories is planned for a normal road use.
* Move hoses so that they do not fall inside the belly pans. Any deterioration due to flows of corrosive products is not guaranteed.
* Aluminium screws are garanted until 6 Nm by our suppliers. Care to excessive clampings which may damage or break screws.
- 4 screws BHc 6×20mm
- 4 screws BHc 5×15mm
- 4 locknuts Ø5
- 1 steel washer Ø6
- 1 plastic cable tie
brackets while fitted on belly pan).
ATTENTION
FITTING INSTRUCTIONS
"BELLY PAN"
CB 600 HORNET 2007 → ∞
Left Hand Brackets
Insert steel washer between bracket & casing
so that they will not
Publicité
