evolution lighting 20745-000 Mode D'emploi page 4

Timer Operation Manual
Troubleshooting
If the timer does not work properly once
plugged in:
1. Check "Timer Setting" and follow setup
directions. Make sure time and date is
set correctly.
2. Check "Timer Setting", make sure D+
setting is for correct days. For every day
use, the setting must display "MON TUE
WED THU FRI SAT SUN".
3. Check "Timer Setting" and follow step (4).
Check for any incorrect programmed time
periods and remove.
4. Press and hold "C" to initiate a reset of
the Timer.
This will restore the factory defaults.
Operating Instructions
Please read the instruction carefully before using it, and keep this
Instruction Manual.
1. Keyboard Lock
Hold the "C/R (Clear / Reset)" button for more than 3 seconds until " "
appears. Repeat to Unlock.
2. Setting the Current Time
While holding the "
"M+" to adjust the Minute, and "D+" to adjust the day settings.
3. Timer Setting
(1) Set up of the first Turn On: press "
the screen will show "1ON". Use "H+", "M+", and "D+" keys to set the
time of Turn On. To turn on at the same time every day, please
choose "MON TUE WED THU FRI SAT SUN".
(2) Set up of the first Turn Off: press "
the screen will show "1OFF". Use "H+", "M+", and "D+" keys to set
the time of Turn Off. To turn off at the same time every day, please
choose "MON TUE WED THU FRI SAT SUN".
(3) Continue to press "
20 ON/OFF periods can be set. The screen will show 2ON, 2OFF,
3ON, 3OFF.....20ON, 20OFF. Press "
timer setting and return to clock display.
(4) To Check the Timer Setting, press "
correct. Press "
(5) Press "MANUAL" to turn power on and adjust automatic setting.
*Press "MANUAL" to Turn On. Display will show "ON".
*Press "MANUAL" to Turn Off. Display will show "OFF".
*Press "MANUAL" to Turn On, then press "AUTO". The device is
on and in automatic state. Will automatically turn on and off per
the Timer Setting.
*Press "MANUAL" to Turn Off, then press "AUTO". The device is
off and in automatic state. Will automatically turn on and off per
the Timer Setting.
Example: The unit turns on at 18:00 every day, and turns off at 07:00 the
next day.
A: Follow (1) to program screen as shown in Picture 1a.
B: Follow (2) to program screen as shown in Picture 1b.
C: Follow (4) to check settings.
D: Follow (5) Press to display "OFF", then press to display "AUTO".
Picture 1a
For Customer Assistance:
www.evolutionlightingllc.com
Made In China
(Clock)" button, press "H+" to adjust the Hour,
(Program)", the bottom left of
(Program)" again, the bottom of
(Program)" to set additional time periods. Up to
(Program)" again to end
(Program)" to check if time is
(Clock)" to finish.
Picture 1b