Publicité
Les langues disponibles
Les langues disponibles
Fitting kit
- 4 self-tapping screws.
- 2 beleved spacers.
Assembly
- Remove the saddle and the two side panels.
- Disconnect and remove the rear indicators.
- Cut out the original number plate support under the taillights, keeping the original storage case.
- Position the Ermax undertray.
- Replace the side panels, and then fix the undertray on them using the provided self-tapping screws.
- Rivet the number plate on its support.
- If necessary, fix the plate with the supplied beleved spacers.
* Painted and varnished parts are not guaranteed against high pressure steam washes or aggressive cleaning products which can damage them and unstuck the varnish. We advise moreover, according to the technical data
of our painting suppliers, to wait one month to obtain a complete polymerization of varnish.
* Accessories gone up on the motorbike will not be any more considered as new and will be neither retaken nor exchanged.
* Ermax accessories are foreseen for original equipments. They will not be guaranteed if they are used in others conditions.
* Due to vehicles made tolerances, beyond our control, some Ermax products might need adjustings to fit.
* Any deterioration of the parts due to the presence of any excessive load in the undertray will not be guaranteed.
* A few tyres, as Dunlop D207 or Michelin Pilot Power, not being for the given dimensions, are not compatible with undertray and rear hugger made for original tyres in standard dimensions.
* Harden the rear shock absorber while drivings with load or on dented roads.
The Ermax mudguard and undertray are not compatible.
FITTING INSTRUCTIONS
UNDERTRAY
«
CBR 900 1996/1997
« CAUTION »
»
Original tyre in 180.
Publicité
