Publicité
Les langues disponibles
Les langues disponibles
Fitting kit
- 2 threaded fasteners
- 1 fitting bracket
Assembly
Position the threaded fasteners as indicated on the picture.
Place the bracket as indicated on the photo.
Before tightening completely, place the seat cover on the bike, center it (move the fasteners position if
necessary), remove it and tighten the screws so as to block the bracket location.
The self-adhesive rubber pad is used to prevent the seat cover from striping the rear seat unit at the
disassembling moment.
The existing space between the tip of the seat cover and the rear seat unit is voluntary, and is used to remove the
seat cover more easily.
* Painted and varnished parts are not guaranteed against high pressure steam washes or aggressive cleaning products which can damage them and unstuck the varnish. We advise moreover, according to the technical data of our
painting suppliers, to wait one month to obtain a complete polymerization of varnish.
* Accessories gone up on the motorbike will not be any more considered as new and will be neither retaken nor exchanged.
* Ermax accessories are foreseen for original equipments. They will not be guaranteed if they are used in others conditions.
* Due to vehicles made tolerances, beyond our control, some Ermax products might need adjustings to fit.
* Aluminium screws are garanted until 6 Nm by our suppliers. Care to excessive clampings which may damage or break screws.
- 2 BHc 5x15 steel screws (little head)
- 1 self-adhesive rubber pad
"ATTENTION"
FITTING INSTRUCTIONS
"SEAT COVER"
ZX6R 2007/2008
Position of self-adhesive rubber pad
Publicité
