Publicité
Les langues disponibles
Les langues disponibles
Fitting kit
- 1 fitting bracket
- 4 Ø5 rubber threaded fasteners
- 1 Carbon Look support
Assembly
- Remove the original head fairing and loosen the 2 screws shown on the picture. Then remove the
central screw.
- Place the fastener on the fitting bracket. Insert the provided bracket between the whole of the
meter and the original fitting bracket of the meter.
- Place the Carbon Look support. Replace the 2 original clips at their location. Put the BHc 5x20
screw at the middle of the support.
- Place the inserts into the support. Place the screen. Tighten it thanks to the remaining screws.
Spacers have to be inserted between the screw and the screen, and between the screw and the
support not to damage the piece.
* Accessories gone up on the motorbike will not be any more considered as new and will be neither retaken nor exchanged.
* Ermax accessories are foreseen for original equipments. They will not be guaranteed if they are used in others conditions.
* Due to vehicles made tolerances, beyond our control, some Ermax products might need adjustings to fit.
* Aluminium screws are garanted until 6 Nm by our suppliers. Care to excessive clampings which may damage or break screws.
FITTING INSTRUCTIONS
- 5 BHc 5x20 screws (small head)
- 5 Ø5plastic washers
- 1 threaded fastener
Screws to loosen
« CAUTION »
« NOSE FAIRING »
CB 1000 R 2008 → ∞
Screw to remove.
Bracket's location
Publicité
