Publicité
Les langues disponibles
Les langues disponibles
Fitting kit
- 4 self-tapping screws.
- 2 beleved spacers.
Assembly
- Remove the saddle, the side panels, the number plate support and taillights.
- Cut bottom away the number plate support by following the toolbox.
- Cut out the external parts of the toolbox on the right and on the left.
- Place the undertray, then replace the taillights, the rear side panels and the saddle.
- Fix the undertray on the panels, at the lowest level, using the two provided screws.
- Rivet the number plate on its support.
- If necessary, fix the plate with the supplied beleved spacers.
* Painted and varnished parts are not guaranteed against high pressure steam washes or aggressive cleaning products which can damage them and unstuck the varnish. We advise moreover, according to the technical data of
our painting suppliers, to wait one month to obtain a complete polymerization of varnish.
* Accessories gone up on the motorbike will not be any more considered as new and will be neither retaken nor exchanged.
* Ermax accessories are foreseen for original equipments. They will not be guaranteed if they are used in others conditions.
* Due to vehicles made tolerances, beyond our control, some Ermax products might need adjustings to fit.
* Any deterioration of the parts due to the presence of any excessive load in the undertray will not be guaranteed.
* A few tyres, as Dunlop D207 or Michelin Pilot Power, not being for the given dimensions, are not compatible with undertray and rear hugger made for original tyres in standard dimensions.
* Harden the rear shock absorber while drivings with load or on dented roads.
The Ermax mudguard and undertray are not compatible.
« CAUTION »
FITTING INSTRUCTIONS
UNDERTRAY
«
CBR 900 1998/1999
Original tyre Michelin in 180.
»
Publicité
