Publicité
Les langues disponibles
Les langues disponibles
Fitting kit
- 6 Ø5 threaded rubber inserts
- 6 Ø5 plastic washers
- 1 Carbon Look support
Assembly
- Remove the original screen. Place the seal on the provided screen support as indicated on the photo
(the seal is showed by the white line). Heat the seal before place it.
- Position this support on the motorbike : screw on and center it with original screws.
- Put the inserts on the support. Then place and fit the screen thanks to the provided screws and
washers.
* Accessories gone up on the motorbike will not be any more considered as new and will be neither retaken nor exchanged.
* Ermax accessories are foreseen for original equipments. They will not be guaranteed if they are used in others conditions.
* Due to vehicles made tolerances, beyond our control, some Ermax products might need adjustings to fit.
* Aluminium screws are garanted until 6 Nm by our suppliers. Care to excessive clampings which may damage or break screws.
HONDA 250 FORZA 2008/2010
- 6 5x15 BHc screws
- 1 meter of seal
« CAUTION »
FITTING INSTRUCTIONS
« SCREEN »
Publicité
