Publicité
Les langues disponibles
Les langues disponibles
Fitting kit
- 4 BHc 6x20 screws
- 4 Ø6 plastic washers
Assembly
- Remove the passenger saddle and disconnect the plate lighting.
- Remove the original number plate support.
- Connect the plate lighting and place the provided plate holder.
- Fit it thanks to the furnished screws.
- Fit the number plate on its support.
* Painted and varnished parts are not guaranteed against high pressure steam washes or aggressive cleaning products which can damage them and unstuck the varnish. We advise moreover, according to the technical
data of our painting suppliers, to wait one month to obtain a complete polymerization of varnish.
* Accessories gone up on the motorbike will not be any more considered as new and will be neither retaken nor exchanged.
* Ermax accessories are foreseen for original equipments. They will not be guaranteed if they are used in others conditions.
* Due to vehicules made tolerances, beyond our control, some Ermax products might need adjustings to fit.
* A few tyres, as Dunlop D207 or Michelin Pilot Power, not being for the given dimensions, are not compatible with undertray and rear hugger made for original tyres in standard dimensions.
* Aluminium screws are garanted until 6 Nm by our suppliers. Care to excessive clampings which may damage or break screws.
FITTING INSTRUCTIONS
« ATTENTION »
« PLATE HOLDER »
ZX 10 R 2006/2007
Publicité
