Publicité
Les langues disponibles
Les langues disponibles
Fitting kit
- 4 rubber spacers
- 4 plastic washers
- Aluminium nettings
Assembly
- Remove the original radiator covers.
- Cut the rubber strip into 2 equal lengths and fix to the lower edge of the air filter cover which be in
contact with the radiator covers.
- Fix the radiator covers using the screws and washers provided and insert the rubber spacers
between radiator and the radiator covers.
- Aluminium nettings can be put in option at the air intakes, with silicone.
* Painted and varnished parts are not guaranteed against high pressure steam washes or aggressive cleaning products which can damage them and unstuck the varnish. We advise moreover, according to the
technical data of our painting suppliers, to wait one month to obtain a complete polymerization of varnish.
* Accessories gone up on the motorbike will not be any more considered as new and will be neither retaken nor exchanged.
* Ermax accessories are foreseen for original equipments. They will not be guaranteed if they are used in others conditions.
* Due to vehicles made tolerances, beyond our control, some Ermax products might need adjustings to fit.
* Aluminium screws are garanted until 6 Nm by our suppliers. Care to excessive clampings which may damage or break screws.
- 4 screws (6×20mm)
- 30 cm rubber strip
Position of rubber strip on air filter cover
« CAUTION »
FITTING INSTRUCTIONS
« RADIATOR COVERS »
FZ1 2006 → ∞
Publicité
