Bosch Tassimo TAS 65 Serie Notice D'utilisation page 35

en
Problem
Water dripping from
the brewing unit.
Water on the surface
under the cup stand.
Service T DISC is
damaged or lost.
Fill tank lights up
P
even though there is
sufficient water in the
tank.
7d and 7e
P Q
are flashing simulta-
neously and it is not
possible to prepare
drinks.
Descale flashes
Q
even though you are
using filtered water.
Filter cartridge change
indicator is not working
anymore.
Cup lighting and LC-
display have turned off
Can I turn off the cup
lighting?
More Customer Service information is available online at www.tassimo.com
Possible cause
The T DISC is damaged or
leaky.
The piercing unit is either
not inserted or not inserted
properly.
Water from condensation.
The Service T DISC must
always be used for cleaning
and descaling processes.
The float in the water tank is
stuck.
There is a fault on the
machine.
Even filtered water contains
small amounts of dissolved
lime.
Please proceed as described
on page 22.
After 5 min. of inactivity,
machine automatically reverts
to stand-by mode to save
energy
–
Solution
Stop the brewing process,
remove the T DISC and clean
the brewing unit.
Check to ensure that the
piercing unit is inserted
properly.
Condensation may occur and
is not a fault. Remove it by
wiping with a cloth.
Contact
the TASSIMO careline
08 00 032 88 33.
Clean the water tank and
ensure that the float can
move.
Turn the machine off using
the on/off switch, wait
approximately 5 minutes and
turn the machine back on.
If 7d and 7e are still
P Q
flashing, please contact the
TASSIMO careline.
08 00 032 88 33.
Descale the appliance.
If filter cartridge change
indicator is still not working,
please contact TASSIMO
careline at 08 00 032 88 33.
To re-activate, please open
and close brewing unit or
touch start/stop button
No, the cup lighting is
automatically switched on and
off when machine is activated.
33
10/2008