IKA EH 4 basic Mode D'emploi page 8

Contents
Guarantee
Safety instructions
Proper use
Unpacking
Commissioning
Installation, filling and emptying
Starting
Setting of the safety temperature
Maintenance and cleaning
Associated standards and regulations
Accessories
Technical data
List of spare parts EH4 basic
Spare parts diagram EH4 basic
Safety instructions
Caution: With this equipment only media may be worked on/or
heated, whose flash point lies over the adjusted safety tempera-
ture delimination. Value for safety temperature limit see chapter
„Technical data". Examine regulary the function of the safety
temperature limiter (see section "Setting of the safety tempera-
ture").
The instrument may not be operated in rooms with explosion
hazard.
Never place the unit in operation without sufficient bath liquid.
Risk of burns: Danger when touching the housing
parts and the heater coils. The temperature of the
heater coils can very rise. Before placing the device
in service, please make certain that it is set to the lowest tem-
8
Page
2
8
9
10
10
10
10
11
11
11
12
12
12
19
•
perature. Otherwise, the device will begin heating up to the
last temperature to be set.
After an interruption in the power supply during the tempera-
ture control process, the device starts back up by itself.
•
= Minimum
distance to
bath vessel
= 8mm
•
•
EH4b 1204