Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Parts Included
A. Waste Bin (2)
B. Wire Cage (2)
C. Sliding Base Assembly (1)
D. Handle (1)
E. Cage Locking Clip (2)
F. Mounting Screws (4)
A
B
C
Mounting
Straps
Sliding Members
D
E
Tools Required
• Phillips head screwdriver
• Drill with 1/16" (1.5mm) bit for
drilling pilot holes
• Pencil
Product Assemblies
BSC12-2-27-R
SBM12-2-27
SCB-12-2-27
SBM15-2-20
SCB-15-2-20
SBM15-2-35
SCB-15-2-35
2700 Oak Industrial Drive NE , Grand Rapids, MI 49505 USA
800.253.1561 • 616.459.3311 • www.kv.com
Inspect all parts and read all instructions prior to beginning assembly and installation.
1.
Place sliding base assembly on cabinet floor, in desired position. Position front mounting strap
against the back edge of the cabinet face frame. (If installing in a frameless cabinet, measure 1/2"
to 3/4" back from front of cabinet opening, and align sliding base assembly parallel to cabinet
opening.) Close door to make sure the assembly will not hold cabinet door open. Also, check to see
if unit will clear the door opening when fully extended. Once position is determined, fasten in place
using four mounting screws provided and a Phillips head screwdriver.
Optional Step: Mark placement of mounting holes with a pencil, remove sliding base assembly and
drill pilot holes for fastening screws. Place sliding base assembly back into position and fasten with
the provided screws.
IMPORTANT: The front and rear wire cages are different. Install the rear cage first.
2.
Install the rear wire cage first. Fully extend sliding members out of the cabinet. Place the slotted
holes on the cage onto the tabs on the left hand sliding
member. (2A) Rest the cage on top of the clip retainers on
the right hand sliding member, but, DO NOT PUSH DOWN.
Close unit so that the wire cage is completely inside of the
cabinet. Now, push down firmly on the right side of the
wire cage, until it is fully seated into the clip retainers. (2B)
Repeat the same process for the front wire cage. (Again,
do not push the cage into the clip retainers until the cage
is completely inside the cabinet.)
3.
Install cage locking clip as shown.
4.
Clip handle onto front of cage.
1
F
2B
Clip
Retainer
Clip Retainer
©2014 Knape & Vogt. All rights reserved. Made in USA. Knape & Vogt
Sliding Double Waste Bin
2A
3
Step 1
Step 2
reserves the right to change specifications without notice.
®
Front
Tab
Pull Bottom
Push Top
Push Bottom
Push Top until it snaps
Rear
4
310370-C_0615
Publicité
Table des Matières
