Maytag JETCLEAN II DAX3000AX Serie Mode D'emploi page 6

Step 2, cont'd:
• Remove the backer material from all five (5) pieces
of mounting tape now applied to the back of the
wood panel.
• Slip the tabs on the upper edge of the bezel up under
lower lip of the control panel.
• Center the wood panel under the bezel making sure
the holes drilled near the top edge of the back side
of the wood panel align with the posts protruding
from the bottom tabs of the bezel. This will ensure
the bezel and panel are aligned properly.
• Press the wood panel firmly onto the dishwasher to
make sure the foam tape makes good contact.
Step 3:
Attach Mounting Trim to Door
• Carefully lower door until it is all the way down. It
may now seem quite heavy. Later, you will adjust the
springs to compensate for the weight of the door.
• Loosen the six (6) screws indicated in Figure 6 using
the T-20 screwdriver until they are about
the plastic Inner Door, or about 4 full turns.
FIGURE 7 – Mounting Strip Placement
Part No. 6 918172 A
FIGURE 5 – Foam Tape Placement
/ " above
1
4
FIGURE 6 – Mounting Screws to be Removed
• Insert the Mounting Trim Strip into the space provided
between the plastic Inner Door and the Steel Outer Door
that came with your dishwasher as is shown in Figure 7.
Make sure the holes for the mounting screws line up with
the holes in the steel Outer Door and the plastic Inner Door.
5 DAX3000AX*/DAX3090AX*