Basic Set Up - Fellowes Powershred W-61Cb Instructions

A.
B.
C.
D.
E.
CAPABILITIES
Will shred: Paper, plastic credit cards, staples and small paper clips
Will not shred: Adhesive labels, CD/DVDs, continuous form paper, transparencies,
newspaper, cardboard, large paper clips, laminates, file folders, X-rays or plastic other than
noted above
Paper shred size:
Cross-Cut ......................................................................................................4mm x 50mm
IMPORTANT SAFETY INSTRUCTIONS — Read Before Using!
manual. Read the entire instruction manual before operating shredders.
set to off or unplug when not in use.
DO NOT use aerosol products, petroleum based or aerosol lubricants on or near
shredder. DO NOT USE "CANNED AIR" OR "AIR DUSTERS" ON SHREDDER. Vapors from
near or over heat source or water.
BASIC SHREDDING OPERATION
Continuous operation: Up to 8 minutes maximum
NOTE: Shredder runs briefly after each pass to clear entry. Continuous
operation beyond 8 minutes will trigger 20-minute cool down period.

BASIC SET UP

CASTER INSTALLATION
1 2
2
F
.
G.
H.
KEY
A. SafeSense
B. Paper entry
C. Pull-out Bin
D. Window
E. Casters
) to back out
PAPER/CARD
1
Plug in and put
disconnect power
switch in ON (I) position
3 4
® Technology F. Disconnect power switch
1. OFF
2. ON
G. See safety instructions
Maximum:
Sheets per pass ........................................................................................................... 10*
Cards per pass ............................................................................................................... 1*
Paper entry width .................................................................................................. 230mm
* A4 (70g), paper at 220-240V/50/60 Hz, 1.4Amps; heavier paper, humidity or other than
rated voltage may reduce capacity. Maximum recommended daily usage rates: 200 sheets;
5 credit cards. 10 sheets per pass.
Fellowes SafeSense ® shredders are designed to be operated in home and office environments ranging
between 50 – 80 degrees Fahrenheit (10 – 26 degrees Celsius) and 40 – 80% relative humidity.
operate shredder. In case of emergency, move switch to OFF ( ) position. This action
will stop shredder immediately.
voltage and amperage designated on the label. The grounded outlet or socket must be
extension cords should not be used with this product.
2 3
Set to Auto-On ( ) Feed paper/card
straight into paper
entry and release
ENGLISH
Model W-61Cb
H. Control Switch and Indicator lights
1. Reverse
2. OFF
3. Auto On (blue)
4. SafeSense ® indicator (yellow)
5. Overheat (red)
6. Door Open/Bin Full (red)
7. Remove Paper (red)
converters, transformers, or
4
When finished
shredding set to
OFF ( )