Maintenance; Power Cord - Dexter power S1T-YH-13B Consignes De Sécurité

7. MAINTENANCE

Before and after each use, check the product and accessories (or attachments) for wear and
damage. If required, exchange them for new ones as described in this instruction manual.
Observe the technical requirements.

Power cord

If the power cord is damaged, it must be replaced by the manufacturer, its service agent or
similarly quali ed persons in order to avoid a safety hazard.
Carbon brush replacement
If the carbon brushes need to be replaced, have this done by a quali ed repair person (always
replace the two brushes at the same time)
Repair
This product does not contain any parts that can be repaired by the consumer. Contact an
authorised service centre or a similarly quali ed person to have it checked and repaired.
Storage
•
Switch the product o and disconnect it from the power supply.
•
Clean the product as described above.
•
Store the product and its accessories in a dark, dry, frost-free, well-ventilated place.
•
Always store the product in a place that is inaccessible to children. The ideal storage temperature is
between 10°C and 30°C.
•
We recommend using the original package for storage or covering the product with a
suitable cloth or enclosure to protect it against dust.
• Clean the product with a dry cloth. Use a brush for areas that are hard to reach.
• In particular, clean the air vents (15) after every use with a cloth and brush.
• Remove stubborn dirt with high pressure air (max. 3 bar).
NOTE: Do not use chemicals, alkaline, abrasive or other aggressive detergents or
disinfectants to clean this product as they might damage its surfaces.
• Check for worn or damaged parts. Replace worn parts as necessary or contact an authorised
service centre for repair before using the product again.
EN
25