Table des Matières
Publicité
ASSEMBLY
For safe use of your product and to avoid serious injury:
• Perform leak checks outside, in a well-ventilated area.
• Operate at least 1m/3.3ft away from combustible materials and ignition
sources.
• Before each use: Keep stove area clear and free from combustible
materials, gasoline, and other flammable vapors and liquids.
• Do not obstruct the flow of combustion and ventilation air to the stove.
• Place stove on a flat, level surface, at least 1m/3.3ft away from any
combustible materials or ignition sources.
• Perform LEAK CHECK PROCEDURE (see pg. 4) before proceeding.
• Release the latch (1.1) to open the lid (1.2). Open side-windscreens(1.3) and
secure by inserting tabs into latches in the lid (1.4).
• Ensure that both control valves (1.5) are closed firmly (rotate clockwise).
• Check that Gasket (2.1) at Fuel Input connection (1.6) is in place and in good
condition before connecting to the Regulator.
Do not use the appliance if it has damaged or worn seals;
WARNING
this may result in gas leakage.
• Connect Fuel Regulator (3.1) to the Fuel Input port (1.6) located on the center
of the right side of the stove by threading Coupling clockwise.
• Connect Propane Cylinder (4.1) (sold separately) into Fuel regulator (4.2) by
threading clockwise in the orientation shown in Fig. 4.
Never operate stove with Propane Cylinder in an inverted
WARNING
position (Fig. 5). Flaring can occur.
(For Ignite Plus Stoves Only)
• Install the four adjustable feet (6.1) into stove base (6.2) by threading
clockwise as shown in Fig. 6.
5
WARNING
Fig. 1
1.4
1.3
1.5
1.1
1.7
Fig. 2
2.1
Fig. 3
Fig. 5
Fig. 4
4.2
3.1
Fig. 6
Fig. 7
6.2
6.1
1.2
1.4
1.3
1.6
4.1
10
Publicité
Table des Matières
