Table des Matières
Publicité
10
ULTRABASS BXD3000H
ULTRABASS BXD3000H Controls
(2)
(3)
(5)
(6)
(7)
(4)
(16)
(8)
(10)
(12)
(14)
(15)
(9)
(11)
(13)
(17)
(20)
(19)
(18)
(21)
(22)
11
Quick Start Guide
Step 2: Controls
(EN)
(1)
(1) The POWER switch turns the amplifier on.
(13) Push this ON button to activate the
ULTRABASS function. The LED in the button
(2) Connect your bass guitar to the INPUT jack
will light up to indicate ULTRABASS is on.
using a ¼" mono plug (unbalanced).
You can also control this effect with the
(3) The GAIN 1 knob adjusts the input gain for
included footswitch.
channel 1.
(14) Use the MASTER control to set the
(4) The CH 2 button switches between channel 1
overall volume.
and channel 2. This can also be done using the
(15) The PHONES jack is for connecting a
included footswitch.
pair of headphones.
(5) The GAIN 2 knob adjusts the input gain for
(16) Power is supplied via the included
channel 2. As you turn the knob clockwise,
IEC connector.
the distortion effect is continuously
blended in.
(17) Use the balanced DIRECT OUTPUT (XLR) to
route the audio signal from your BXD3000H
(6) The SHAPE knob adjusts which frequencies are
to the input on a mixing console.
scooped out of your bass tone. It only affects
channel 2.
(18) Connect your BXD3000H to an external
speaker using a speaker cable connected to
(7) The LEVEL knob adjusts the volume of
the SPEAKER OUTPUT jack.
channel 2. Use this control to balance the
volume between channels 1 and 2.
(19) Connect the SEND jack to the input on
your effects device. Connect the output on
(8) The FBQ EQUALIZER has 7 slide controls,
the effects device to the RETURN jack on
one for each frequency band. The maximum
the BXD3000H.
boost/cut is 12 dB.
(20) The CD IN jacks (RCA) allow you to connect an
(9) The FBQ switch activates the FBQ
external stereo signal. For example, you can
spectrum analyzer. The control LEDs, normally
play along with music from a CD or MP3 player.
identical when FBQ is off, now show the
energy content of each frequency band
(21) Send your signal (before the power
with a corresponding degree of brightness.
amp stage) via the LINE OUT jack with a
The equalizer is always active regardless of the
¼" mono cable (unbalanced).
FBQ function.
(22) Connect the included footswitch to the
(10) The COMPRESSOR knob controls the
FOOTSW(ITCH) jack to switch between
compression intensity.
channels and activate/deactivate the
ULTRABASS function.
(11) Push this ON button to activate the compressor
for both channels. The LED in the button will
light up to indicate the compressor is on.
(12) The ULTRABASS control allows you to add
ultra-low frequencies one octave below your
bass signal. The ULTRABASS effect is available
for both channels.
Publicité
Table des Matières
