Maintenance / Cleaning - GE current Evolve EFM1 Manuel D'installation

3
WIRING
Note: Make all electrical connections in accordance with
National Electrical Code and any applicable local code
requirements.
Note: Verify supply voltage matches nameplate rating
before wiring.
• Verify service leads meet nameplate temperature rating.
• Units are provided with cable or leads exiting the
fixture for connection with service leads.
• For Pipe and Wall Mount open wire cover and connect
service lead to luminaire leads. Reclose wire cover.
• For Trunnion Mount connect service lead to luminaire
cable wiring.
• If cable or leads are removed and customer connects
service leads directly to the terminal board, see Table
1 for screw torque requirements.
Table 1. Terminal Board Screw Torque (UL Units):
Wire Range Copper Aluminum Torque (in lbs.)
10-16 SOL, STR
8-6 SOL, STR
Wired Dimming:
• Connect wired dimming control leads per Table 2.
Table 2. Wired Dimming Control Connections
0 VDC (-)
Up to 10 VDC (+)
4
AIMING
FIGURE 4. Aiming Sight
An "aiming-sight" for point aiming is provided on the
top of the luminaire.
• Tilt or Rotate luminaire to align the front and rear
sights so that equal space shows on either side and
the desired target point is centered in the groove.
• Tighten trunnion or knuckle bolts per instructions in
Section 2.
30
STR6, SOL, STR 45
Gray Lead
Violet Lead
Front of sight
Target
Rear of sight
60° MAX
FIGURE 5. Maximum Aiming Range with PE
PE Units: Regardless of mounting type, units with a
photoelectric receptacle cannot be aimed more than
60° degrees above horizontal.
5

MAINTENANCE / CLEANING

Risk of electric shock. Make certain power is off before
attempting any maintenance.
• Occasional cleaning of the outer lens surface may
be needed.
• Use a mild non-abrasive soap or detergent,of
neutral pH (pH approximately 6 to 8), which contains
no chlorinated or aromatic hydrocarbons.
• Wash thoroughly, using a soft cloth.
• Rinse with clean, cold water and wipe dry.
6
STORAGE
• Packaged units should NOT be stored unprotected
outdoors in corrugated (cardboard) boxes.
• Store packaged units in a covered dry area not
exceeding -40 °C (-40 °F) to 50 °C (122 °F) such as a
roofed area or covered with a secured tarp to keep
water off the corrugated (cardboard) packaging.
7
CONTROLS
• If using a PE socket-based control, refer to instructions
included with control regarding appropriate settings
for dimming and other control features.
WARNING