Planning Your System - Ground Zero RADIOACTIVE Serie Mode D'emploi

Masquer les pouces Voir aussi pour RADIOACTIVE Serie:

Mode d'emploi (8 pages)

Manuel du propriétaire (4 pages)

Mode d'emploi (4 pages)

Table Des Matières

Table des Matières

Les langues disponibles

•

Screwdriver

•

Electric drill, 3 mm / 0.12" carbide drill bit

•

Mounting screws

•

Power wire min. 20 mm² / 4 AWG

•

Ground wire min. 20 mm² / 4 AWG

•

Speaker wire min. 2 x 1,5 mm² / 15 AWG

•

As a precaution it is advisable to disconnect the vehicle's battery before making connection

to the +12 Volts supply wiring (see owner's manual of your car for further information).

•

Please use great caution drilling your trunk. Your gas tank and brake lines can be damaged by puncturing with your drill bit –

this could cause damage or failure of your cars operating systems.

•

Never pass wires over sharp angles. It is recommended to buffer the power supply of the amplifier with a capacitor min. 1

Farad to guarantee a stable operation voltage.

High powered audio systems in a vehicle are capable of generating "Live Concert" levels of sound pressure. Continued exposure to

excessively high volume sound levels may cause hearing loss or damage. Also, operation of a motor vehicle while listening to audio

external sounds such as; horns, warning signals, or emergency vehicles, thus constituting to a potential traffic hazard. In the interest of

safety, Consumer Electronics recommends listening at lower volume levels while driving.

Before beginning the installation, consider the following:

If you plan to expand your system by adding other components sometime in the future, ensure adequate space is left, and

cooling requirements are met.

If your radio / source is equipped with pre-amp outputs, it is possible to utilize them to drive the amplifier and connecting

(amplifier) to the 2 rear speakers.

Select a suitable location that is convenient for mounting, is accessible for wiring

and has ample room for air circulation and cooling.

Use the amplifier as a template to mark the mounting holes, remove the amplifier.

Tools and materials you need

Please note!

WARNING !

equipment at high volume levels may impair your ability to hear