Light Source - Toparc PRO 600L Mode D'emploi

Translation of the original instructions
TECHNICAL DATA

Light Source

Luminous Power
Operating time
Battery Specification
Charging Time
Charging Input
Degree of protection
Operating temperature
WARNING
• Do not open the device.
• Do not look directly into the light emitting lamp - Risk of eye injuries!
• Do not operate in direct sun light or extreme temperature conditions. Operating tem-
perature, ‒10°C to +40°C.
• Keep away from children! Children should be supervised in order to ensure that they
do not play with the device!
OPERATING & CHARGING PROCEDURE
1. Press the Switch first time, top light switch on.
2. Press the Switch second time, top light switch off.
3. Adjust the stepless switch to change brightness of the whole light. Switch lamp off and connect
with USB charger during charging.
The battery indicator will blink during charging.
All the battery indicator will stay lighting up after finished the charging.
If the battery indicator did not light up, please remove the charger and try again.
Always only use the charger recommended by GYS to charge the lamp.
The use of a NON-recommended charger can lead to a fire and destroy the lamp.
Before taking the hand lamp into service for the first time charge it for 4-5 hours.
Fully charge the hand lamp before it is stored for a longer period.
When the battery is running out, the light will flash 3 times to remind customers need
to charge.
SAFETY INSTRUCTION
• Do not use the device if there is damage to the housing, plug or cable. Consult your local autho-
rized specialist!
• Do not open the device! Repair work and replacing the rechargeable battery pack may only be
carried out by electricians.
• Carry out cleaning tasks only when the mains plug is removed from the mains power!
• There is a risk of short-circuit. Repairs on the device may only be carried out by commissioned
and trained persons. Please contact your nearest authorized branch.
• Protect the battery against heat, e. g., against continuous intense sunlight, fire, water, and
moisture. Danger of explosion.
6
PRO INSPECTION LAMP 600L
high power COB LED - Main light
high power SMD LED - Top light
ca. 60-600 lm - Main light(Min-Max)
ca. 120 lm - Top light
ca. 16-1.5 h - Main light full power mode
ca. 10 h - Top light
Li-ion 3.7 V 2600 mAh, 9.62 Wh
4 hours
DC 5 V 1 A
IP54 , IK07
-10ºC to +40ºC
EN