C1Kd Console; Configuration With 2-Wire Intercom Systems - Vokkero 210189A Mode D'emploi

VOKKERO GUARDIAN EUROPE Wireless Interface (WI) - User Guide V0.1.0
4.1.3.

C1KD console

• Connect an XLR 3 pts cable (male/female) between the "TB OUT" connector on the console and the "IN" connector of the Vokkero Guar-
dian wireless interface.
• Connect an XLR 3 pts cable (male/female) between the "REV TB IN" connector on the console and the "OUT" con-nector of the Vokkero
Guardian wireless interface.
• Connect the Vokkero Guardian wireless Interface power cable to another power supply.
Adopted settings for the WI interface:
Out Audio Gain: 0/6 dB
In Audio Gain: 0/6 dB
Adopted settings for the console:
Volume at 3 / 4 on the console's potentiometer

4.2. Configuration with 2-wire Intercom systems

Operating the WI interface with a 2-wire Intercom system requires the use of a 2-wire/4-wire audio convertor.
Several material tests have been carried out, and we would recommend using the reference:
ALTAIR ALT4W2-200 with a CANFORD YL908 type "Y" cable
We would also recommend offsetting the antenna using an RF cable. Different lengths of RF cable or offset kit are available on request from our
sales department.
The list of different 2-wire Intercom references found below is not exhaustive and the settings for the 2-wire/4-wire convertor and the Guardian
WI Interface are given as an example.
These cables are not included in the kit
GB
Mains outlet cable
Page 35 / 52