Changing Blades; Removing (Fig 2-3); Fitting; Working Instructions - GARDTECH GT19001 Mode D'emploi

7.4

Changing blades

GB
NL
7.4.1

Removing (Fig 2-3)

· Push the blade cover release button (8) and slide the cover (6) towards the On/Off switch
(5).
DE
· Lift away from the housing.
· Lift the blade (1) out.
FR
7.4.2

Fitting

· Fit the blade as shown aligning the holes in the blade onto the drive pins. (Fig
· When refitting the drive cover (6) ensure all 4 location legs are inside the housing prior to
sliding cover into place.
· Slide the blade cover back towards the blade (1) to secure. (Fig 5)

8 WORKING INSTRUCTIONS

8.1

Shrub shear (Fig 6)

8.1.1

Cutting hedges

Cut stems up to 6 mm in thickness. When cutting, move steadily along the line of cut, so that
stems are fed directly into the cutter blades. The double edge of the cutting blade enables
cutting to either direction, or with a side to side motion.
After use replace the blade transport guard.
Recommended cutting/trimming times:
· Cut hedges with deciduous leaves in June and October.
· Cut evergreen hedges in April and August.
· Cut conifer and other fast growing shrubs approx. every six weeks from May onwards.
8.2

Grass shear (Fig 7)

8.2.1

Edging

Guide the machine along the edge of the lawn. Do not allow the blade to contact paved
surfaces, stones or garden walls, since this will wear the blade rapidly.
9 MAINTENANCE
· Check for obvious defects such as loose, dislodged or damaged blade, loose fixings and
worn or damaged components.
· Check that covers and gua rds are undamaged and correctly fitted. Carry out necessary
maintenance or repairs before using.
· If the machine should happen to fail despite the care taken in manufacturing and testing,
repair should be carried out by our technical department.
Wear gloves when changing the blade.
Keep your fingers away from the blades.
Before cutting check the hedge for foreign objects e. g. wire fences.
Note: To ensure long and reliable service, carry out the following
maintenance regularly.
12
4)