OPTIKA MICROSCOPES SZM-D Manuel D'instructions page 3

SAFETY GUIDELINES
Connect the mains plug into the socket at the base
Make sure, before you turn the illumination on, that the voltage selector is set to the mains voltage for
your region.
The power cord should be used only on network sockets equipped with adequate grounding.
Contact a technician to check the state of your electrical system. If there is no need to install additional
accessories, the instrument is now ready for use. Once positioned and installed with the necessary
components, the microscope is ready to be used. Your microscope is a laboratory instrument desi-
gned to last. Handle it always carefully and avoid abrupt vibrations or shocks. Always disconnect the
power cable from the microscope when not in use for long time, while you clean it or when you perform
any maintenance.
AvOID DISASSEMBLING THE INSTRUMENT
Do not disassemble the instrument. This entails the cancellation of the warranty and may cause
malfunction.
SZM-D - OPERATION MANUAL
1.0 INSTALLATION OF CAMERA DRIvERS AND SOFTWARE
1.1 Operating system requirements: Windows XP, Windows Vista or Windows 7. If your PC is Windows
XP: before the installation of your Camera please check if Service Pack is installed. If not, please
update your XP from the Microsoft web site. If your PC has a USB port less than .0, there may be
some problems in capturing image from the camera due to the slow transmission.
1.2 Please insert your CD and run:
\ vision lite \ setup.exe
1.3 Now Optika Vision Lite icon appears on your desktop.
1.4 Choose from the folder "\drivers" the model of camera you want to use and select the file
"setup.exe".
1.5 The installer may show warnings about missing Windows certification: ignore such warnings and
select "Continue". Note : do NOT cancel the installation.
1.6 At the end of the installation process restart the PC if requested.
1.7
Plug the Camera in your PC: the camera will be identified and Windows will recognize the driver
which has just been installed from the CD.
Then ignore any message about Windows compatibility and select "Continue" .
Note : do NOT cancel the installation.
1.8 At the end of the identification process, disconnect your Camera and try to plug it again, in order to
Page 3