Publicité
Les langues disponibles
Les langues disponibles
Fitting kit
- 4 threaded fasteners
- 1 fitting bracket
- 2 Ø5 steel washers
- 2 Ø5 L5 plastic spacers
Assembly
Position the threaded fasteners as indicated on the picture.
Place the bracket and the spacers as indicated on the photo.
BHC 5x15 screws
and 6x10 spacers
Before tightening completely, place the seat cover on the bike, center it (move the position of fasteners if
necessary), remove it and tighten screws so as to block the fasteners location.
If the seat cover doesn't fit well, you may position the steel washers or 5x5 plastic spacers between the
bracket and the fasteners for a more precise setting.
If necessary, the self adhesive pads may stabilize the seat cover.
* Painted and varnished parts are not guaranteed against high pressure steam washes or aggressive cleaning products which can damage them and unstuck the varnish. We advise moreover, according to the technical data of our
painting suppliers, to wait one month to obtain a complete polymerization of varnish.
* Accessories gone up on the motorbike will not be any more considered as new and will be neither retaken nor exchanged.
* Ermax accessories are foreseen for original equipments. They will not be guaranteed if they are used in others conditions.
* Due to vehicles made tolerances, beyond our control, some Ermax products might need adjustings to fit.
* Aluminium screws are garanted until 6 Nm by our suppliers. Care to excessive clampings which may damage or break screws.
- 2 BHc 5x15 steel screws (little head)
- 2 BHc 5x20 steel screws (little head)
- 2 self-adhesive rubber pads
- 2 Ø6 L10 plastic spacers
"ATTENTION
FITTING INSTRUCTIONS
"SEAT COVER"
Z 1000 2007/2009
Z 750 2007 → ∞
Z 750 R 2011→ ∞
Estimated assembly time: 15 mn
Publicité
