NAD C 555 Manuel D'installation page 5

GOLDRING ELEKTRA CARTRIDGE
Your NAD C 555 turntable comes with a factory fitted Goldring Elektra moving magnet cartridge.
When following the setting-up instructions, please note that the optimum tracking weight is 1.7 grams
for the cartridge. The bias adjustor should then be set to the same setting.
Replacement styli are available from your NAD dealer.
Platter
On/off switch
SETTING UP THE CARTRIDGE
With the cartridge fitted using the alignment protractor supplied and the wiring chart (shown left), next
set the tracking force and thrust bias.
First, slide off the plastic protection shroud from the cartridge - carefully! Unclip the arm from its holder
and make sure that the bias adjuster is set to zero, use the balance weight to 'float' the stylus about 1mm
clear of a record, then dial inwards with the weight, (1 complete turn = 2g) until the cartridge's tracking
weight is achieved. Finally, set the bias adjuster to the same setting.
Spindle
Sub platter
Bearing
Mat
ARM WIRING
Blue = LH earth
Green = RH earth
Red = RH signal
White = LH signal
Anti-vibration feet
Tonearm Counterweight
Bias adjustment
Lift/lower
mechanism
Arm clip
Plinth
5