SOUND2GO BRIQ Studio Mode D'emploi page 48

EN
Pairing process to note
When device detected S2GBRIQ, initiate and paired them. Should device request for password, enter
default password „0000", press OK button to complete the pairing. NOTE: If pairing fails, please refer to
„Troubleshooting."
Pairing by NFC: Activate NFC on your musicsource and hold it at the bottom of the BRIQ Studio near the
NFC logo. Confirm the connection.
Change function mode
Long press the Play/Pause button to disconnect the current connection from bluetooth to 3,5 mm jack input
device. In this mode, the connected equipment can not be operated via the buttons on the speakers.
45