Long Term Storage Of Your Heater - Dyna-Glo Pro RMC-KFA45DGP-01 Manuel De L'utilisateur Et Instructions D'utilisation

NEVER LEAVE THE HEATER
UNATTENDED WHILE BURNING!
NOTICE : The major electrical components of this heater are protected by a safety fuse mounted to the PCB board.
If your heater fails to start, check this fuse first and replace as necessary.
power source to insure that proper voltage and frequency are being supplied to the heater.
TO STOP HEATER
1. Turn switch to "OFF" and unplug power cord.
TO RESTART HEATER
1.Wait 10 seconds after stopping heater.
2. Repeat steps under to start heater.
EXTRA ELECTRIC OUTLET & PIGGYBACK POWER CORD
WARNING : SHOCK HAZARD!
• Always cover electric outlet when not in use.
• Don't plug and use a appliance more than 120V/60Hz 5A
current in this outlet
LOUVER(RMC-KFA210TDGP-02 Model Only)
CAUTION : RISK OF BURN
Louver is Extremely Hot in operation and after shut-off.
Never touch or control angle while operating or still Hot.
-Louver's angle can be controlled by turning handle in direction
of arrow as shown in Figure 11. (Control range : Up 28 /Down 20 )

8. LONG TERM STORAGE OF YOUR HEATER

FUEL TANK DRAIN
1. Drain fuel tank through fuel cap opening.
(For RMC-KFA45DGP-01/75TDGP-01 Models Only)
2. Remove drain plug from rear bottom side of fuel tank by pulling plug grip downward and drain.
(For RMC-KFA125TDGP-01/210TDGP-02 Models Only. See Figure 12)
3. Using a small amount of kerosene, swirl and rinse the inside of the tank.
NEVER mix water with the kerosene as it will cause rust inside the tank.
Pour the kerosene out making sure that you remove it all.
IMPORTANT : Do not store kerosene over summer months for use during next heating season.
4. Reinstall fuel cap. Properly dispose of old and dirty fuel. (For RMC-KFA45TDGP-01/75TDGP-01 Models Only)
5. Reinstall Drain Plug as follows.
(For RMC-KFA125TDGP-01/210TDGP-02 Models Only. See Figure 13)
- Insert plug's seal head fully into drain hole so that flange is flush to tank's bottom.
- Insert seal cap fully into head hole so that cap flange is flush to head flange.
Drain Plug
Figure 12. Drain Plug Removal
IMPORTANT : Reinstall plug fully into hole in tank, Otherwise it will not seal completely.
6. Store heater in dry well ventilated area. Make sure storage place is free of dust and corrosive fumes.
7. Store the heater in the original box with the original packing material and keep the USER'S MANUAL
with the heater.
Using old fuel could damage heater.
Plug Grip
Rear bottom side
of Fuel Tank
Figure 11. Louver Angle Control
Drain Hole
Fuel Tank
Seal Head
Head Flange
Figure 13. Drain Plug Reinstall
9
You should also check your
Cover
Outlet
RMC-KFA210TDGP-02 Model Only
Cover
Outlet
All Models
Figure 10. Electric Outlet
Head Flange
Head Hole
Seal Cap
Cap Flange
Louver
Handle