Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Temperature settings
In the menu only the temperatures are displayed, where you can set the set-point temperature by the selected hydraulic scheme.
By pressing buttons
Current value of
set-point temperature
(numeric mode)
Graphic review
of settings
Manual mode
Factory set mode is "0001".
Parameter
S1.1
HYDRAULIC SCHEME
Parameter
MIN. SETPOINT TEMPERATURE IN
S2.1
HEATING MODE
MAX. SETPOINT TEMPERATURE IN
S2.2
HEATING MODE
For further informations about the controller please read the manual into the packaging
,
and
you choose the required temperature, and a new window opens:
55°C
45
Current value of
set-point temperature
(analogue mode)
This mode is used for testing the system or in case of malfunction. Every output can be manually activated or deactivated.
Move with the buttons
selected by pressing the button
ON, OFF or AUTO starts flashing. Now the output can be changed using the buttons
by pressing the button
Exit the setup menu with the
Function
Selection of hydraulic scheme.
Function
Setting of minimal allowed setpoint temperature in heating
mode. Setpoint temperature cannot be adjusted lower as with
this parameter.
Setting of maximal allowed setpoint temperature in heating
mode. Setpoint temperature cannot be adjusted higher as with
this parameter.
Assembling instrunctions and maintenance
Value of the last
confirmed setting
65
Default value
Setting range
and
between the individual outputs R1, M- or M +. The output, which you want to change is
.
.
button.
Parameter description
Parameter description
und
. The setting is confirmed
Default
Setting range
value
01
01 - 04
Default
Setting range
value
5 ÷ 70 °C
50 °C
10 ÷ 95 °C
70 °C
Publicité
Table des Matières
