Sennheiser Communications UI 760 Notice D'emploi page 9

UI_760.book Seite 5 Freitag, 30. Januar 2009 11:52 11
Connecting the PC to the UI 760
E Connect the RJ11 4/4 plug of the PC connecting cable to
the AUX socket on the UI 760 until it locks in place.
Inserting the battery
When inserted into the UI 760, the battery has a service life
of approx. two years.
Low battery warning
Reduced output volume and a hum noise are heard in the
headset speaker to indicate that the battery is low. Insert
a new battery.
Connect the two jack plugs to the
outputs of your PC sound card as
shown or the USB plug to the PC
USB port.
Remove the lower rear part of the
housing. Use included screw to
tamper-proof the battery cover–
mandatory in some countries.
Insert the battery as shown and
replace the lower rear part of the
housing.
5