Warranty Terms; Features; Installation; Positioning - BERTO'S ARTICOLO Mode D'emploi

If there have been transport damages, immediately inform the driver and, within three days, confirm it by
recorded delivery letter addressed to the forwarder, sending a copy of it also to the producing company or
its reseller.
Every claim must be notified within 8 days from the receiving of the goods, failure to do that the claim shall
not be accepted.

7. Warranty terms

This product is covered by a 12 months warranty starting from the date of the purchase, except for the
electrical components. The spare parts will be eventually supplied under warranty ex works our warehouse.
Before the delivery of spare parts under warranty, there must be the returning of the damaged goods.
The producing company declines any responsibility in case of improper use of the appliance.
The installation must be performed by a qualified technician.
For any technical problem and any request for assistance or intervention, please contact your
authorized dealer or service center only. The necessary information for the dealer or for the service
center are on the CE plate.

8. Features

This product is designed, built and tested to assure the preservation of beverages and food for a short time.
Any other use is improper.

9. Installation

Once unpacked, put the appliance in its final position: the most cool and ventilated place ensures the best
performance and a reduction in energy consumption, since the system is less stressed.
Check the leveling of the refrigerator and the alignment of the doors adjusting the height of legs if
necessary.
Make sure that the electrical socket is easily accessible in the area. Remove the PVC film coating inside
and outside of the product. Make sure the electrical system is provided with an automatic cut-out.
Earthing of electrical system is compulsory. In the event that the product is not kept in operation for a long
time, be sure to disconnect the power plug

9.1 Positioning

The installer must verify the presence of fire prevention regulations, and place the appliance in full obedience of
the industrial injuries legislation and the current regulations.
The appliance works with an air condenser, so it is necessary to pay attention to its placing by keeping free the
side of the incoming of the cooled air.
Besides, it is also necessary to keep it at least at 20 cm from wall or other appliances nearby the air exit, so as
to obtain the best performances.
Avoid placing the appliance in closed or poorly aired spaces, from exposing it directly to sun-beams, and from
heating sources.
The tables with 450, 490 and 520mm height with motor on board, require a continuous exchange of air near the
engine compartment, in order to function.
It is advisable to always keep a minimum free space of 15 cm in the rear area or alternatively from the side of
the engine compartment (see images below).

9.2 Ambient

Depending on the climatic class indicated on the silvered label inside the machine, if the data is 4, then the air-
cooled condensing units work at 32°C ambient temperature maximum; if, otherwise, the data is 5, then the air-
cooled condensing units work at 40°C ambient temperature maximum.
The declared performances are not guaranteed where there are higher temperatures.
12