sanowell PlusTherm Manuel D'utilisation page 10

Medical recommendations
As each massage is individually sensed, it depends on your preference which application
option offered by the sanowell PlusTherm is the most comfortable to you. You may try
whether a soft or intensive stimulation brings you optimum relaxation. In case of medical
questions concerning the application, your physician will most likely glad to be of help.
In the case of inexplicable pain or swelling in the legs or feet, as well as after a muscle
injury, you should consult your physician before application. Discontinue a massage if during
EN
application pain or swelling occur. During pregnancy it is advised to consult your physician
about application.
Operation
Foot bath and massage with water
Before fi lling water into the tub, make sure that the device is not connected to a electrical
source, i.e. you may not connect the cable to an electrical plug until the air bubble foot bath
is fi lled with water and stands securely on the ground!
Foot massage without water
You may use the device for a foot massage without water – the setting switch needs to be
turned to position M (vibrating massage). Heat sensitive persons should put on socks when
using the sanowell PlusTherm without water.
Attention:
If the air nozzles on the bottom of the air bubble foot bath are plugged, the motor may be
damaged. Therefore, please do not use foils or other materials to cover them and do not
stand on the nozzles during use. Warranty will expire in case of noncompliance.
Application
Filling the device with water
The sanowell PlusTherm can be fi lled with up to 4 litre of water. The maximum fi ll-height is
marked on the inside of the air bubble foot bath. You may use cold or warm water with or
without bubbling bath additives.
Setting the function
Sit down comfortably in front of the air bubble foot bath and choose one of the three
different functions by turning the switch.
Choosing warmth
The sanowell PlusTherm is equipped with a innovative warmth function. This new technique
ensues that during an application the water stays constantly at the same temperature
according to setting or heats the water up to 40 °C.