golmar Tekna HF Plus Guide Rapide page 3

PROGRAMMING
Locate on the door panel the SW2 DIP switch situated on the top left-hand
side of the back of the sound module and set number 2 to ON. The door
panel will emit a tone to indicate that it has entered programming mode.
In systems with more than one door panel, only perform this procedure on
the main panel of each building.
Turn off the monitor to be programmed (press button
Once switched off, press door release button
Press and hold door release button and, without releasing it, switch on the
monitor (press button for 1 second).
To show that the device is ready for programming, the door panel and monitor
will emit a number of tones (the status LED on the monitor will illuminate
red), enabling door release button to be released. To establish audio
communication with the door panel, press button
Press the door panel button that will call this monitor.
At this moment, the door panel and monitor will emit a number of tones (the
status LED on the monitor will blink red and the indicator LED will illuminate
red.
To programme the monitor as , press button
Master
monitor's LED will illuminate red).
To programme it as , press button
Slave 1
blink (green) once. Continue successively to
button four times and the status LED will blink (green) four times.
To programme it as , press button
Slave + Intercom
(green) once.
To programme it as (in call), press button
Slave without video
status LED will blink (green) once. If button
will return to being programmed as
Slave with video
status LED will blink (green) twice. The door panel video will be displayed
during a call if programmed to do so.
Make a call to check that the monitor has been successfully programmed.
Programme the other monitors in the same way.
Once the programming has finished, set the programming switch to OFF.
Each apartment must only have one master unit; if there are parallel units,
they must be configured as slaves.
To programme the monitor with a coded door panel or from a
IMPORTANT:
general panel, see the manual of the corresponding door panel.
4
for 3 seconds).
.
.
M
for 3 seconds (the
once and the status LED will
S
, pressing
Slave 4
and the LED will blink
SI
and the
is pressed again, the monitor
SV
(in call) and the
IMPORTANT: For advanced programming, optional connections and
more information, see the TTEKNA HF
https://doc.golmar.es/search/manual/50122337
P
rogramming the Tekna HF Plus monitor with a
button panel.
PLUS manual (code 50122337).
5
TECHNOLOGY
Tekna HF Plus Monitor
Plus Digital System
QUICK GUIDE
GOLMAR S.A.
C/ Silici, 13
08940- Cornellá de Llobregat
SPAIN
Golmar se reserva el derecho a cualquier modificación sin previo aviso.
Golmar se réserve le droit de toute modification sans préavis .
Golmar reserves the right to make any modifications without prior notice.
Code 50122337 TTEKNA HF
golmar@golmar.es
Sistemas de comunicación S.A.
GR REV.0 19 2
PLUS EN
www.golmar.es