Leviton Versi-Duct 491RU-HFR Directives D'installation page 3

Slack Loop Storage Organizer
(PN# 49265-SL1, 49265-SL2)
The Slack Loop Storage Organizer manages and
stores excess cable for future use. The Slack Loop
Storage Organizer is moveable and can be installed
to accommodate different size slack loops.
Install: Slide the Slack Loop Storage Organizer over
the fingers of the Vertical Slotted Duct.
(Figure 4)
NOTE: Bend radius and Slack Loop Storage
Organizer are compliant with ANSI/TIA/EIA
standards.
Cable Retainer
(PN# 49265-WR1) (Used with Vertical and Horizontal Ducts)
The Cable Retainer is designed to hold cable
within the slotted duct. The Cable Retainer has
four notches, so it can be snapped off to
accommodate different size slotted ducts.
Install: Slide the Cable Retainer over the duct
finger until it snaps into place. (Figure 5)
Duct Cover Hinge
(PN# 49265-HNG) (Used with Vertical and Horizontal Ducts)
The Duct Cover Hinge is designed to easily open
and close duct cover for increased protection and
easy access.
Install: Attach duct cover first. Snap hinge
between slotted duct fingers and attach to
one side of duct cover. (Figure 6)
NOTE: Use a minimum of two hinges per cover.
PK-93096-10-02-0E
OR-93096-00-00-03
4
5
6
2