Télécharger Imprimer la page

EFBE-SCHOTT WK 1020 Mode D'emploi page 13

Publicité

Les langues disponibles

Les langues disponibles

Fax +32 2 359 95 50
Open the lid by pressing its release button and fill the tank with fresh water, paying
attention not to fill under the minimum mark and above the maximum mark on the water
level indicator.
Close the lid by pressing it down until you hear a click. Make sure it closes correctly.
Put the jug onto the power base, plug into the wall socket and switch on by pressing down
the switch situated on the handle. The red pilot light comes on indicating the appliance is
operating.
The jug kettle will switch off automatically when the water has boiled. However, you can
stop the jug kettle anytime by putting the switch in the off position.
For instant reboiling, wait until the water has cooled down and switch on the appliance
again.
SAFETY CUT-OUT
This jug kettle is protected with an automatic safety device that switches off the appliance
if it is accidentally switched on without water. Please bear in mind that only the thermostat
is switched off in case of overheating, whereas the switch stays in the ON-position (I).
In this case, switch off the appliance by putting the switch in the OFF position (0) and wait
about 10 minutes for the heating element to cool. Then pour in sufficient cold water to
cover the heating element. This will reset the safety device.
The kettle may then be used as normal.
CLEANING AND MAINTENANCE
Before attempting any cleaning operation, make sure the appliance is unplugged from
the supply socket and fully cooled down.
To clean the exterior surfaces, simply wipe over with a soft damp cloth and dry thoroughly.
Residues on the interior surfaces can be removed with a soft brush.
Never use abrasive products.
On no account must the jug kettle or its power base be immersed in water.
The flocked parts are water-resistant and can be cleaned with a damp cloth.
FILTER
Your appliance is provided with a filter. When you want to boil water, settle the filter first.
When the lid is open, you can remove the particulate filter by gently press out from the
inside to the front at the top and rinse under running water.
The filter should be rinsed clean regularly.
DESCALING
When scale becomes visible in the jug, you have to descale it. To remove scale from the jug
kettle, use products made especially available for this purpose, liquid descaling products or for
the sake of environmental protection you can use vinegar.
When descaling, please pay attention to the following points:
First pour some water in the appliance, and add the descaling product afterwards.
Make sure to dilute the product sufficiently. Please follow the instruction manual of the
descaling product.
When using vinegar, do not use more than 2-3 ml.
Caution, the mixture might froth during heating.
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced
and folded in order to obtain a booklet A5 (+/- 148.5 mm
width x 210 mm height). When folding, make sure you
keep the good numbering when you turn the pages of
the I/B. Don't change the page numbering. Keep the
language integrity.
13
Assembly page 13/26
WK 1020 - 180507

Publicité

loading

Ce manuel est également adapté pour:

180507