Serial Numbers; Cleaning And Maintenance; Accessories - Peg-Perego aria twin Notice D'emploi

could be dangerous.
3 HOODS: the hoods are independent. One or both may
be lowered at any one time. Insert the hood clips into
the appropriate housing (fig_a), button the hoods to
the rear of the backrests (fig_b) and open by pulling
forward (fig_c). To remove the hoods, push the side
buttons and simultaneously slip the hood upwards
(fig_d).
4 COVER: slide the cover on and button it at the side to
the arms of the stroller.
5 CUP-HOLDER: to attach the cup-holder to the centre of
the handlebar, place it in the appropriate housing, as in
the figure.
6 BRAKE: Press down on the brake lever situated on the
rear wheel unit to set the brake on the stroller. Lift the
lever to release the brake. Always set the brake when
the stroller is at a standstill.
7 5-POINT SAFETY HARNESS: to fasten, insert the two
waist strap buckles (with shoulder straps attached)
into the leg divider strap until you hear a click
(fig_a). To release, press the sides of the buckle and
simultaneously pull the waist strap outwards (fig_b).
8 To put on the safety harness, insert the strap adjuster
into the slot in the backrest (fig_a) and remove it after
fastening the harness to allow the child to move freely
(fig_b). Place the strap adjuster just beneath child's
shoulder level so the shoulder straps do not slide off
(fig_c). To tighten the waist strap, pull in the direction
of the arrow on both sides (fig_d). To loosen it do the
opposite. The waist strap may be tightened up to the
safety stop (fig_e).
9 BACKREST ADJUSTMENT: to recline the backrest, lower
the backrest adjuster (fig_a) and simultaneously push
the backrest down (fig_b). To lift the backrest, push the
backrest adjuster up.
10 SWIVEL WHEELS: to make the front wheels swivel,
lower the lever (fig_a). To fix them in place, lift the lever
(fig_b).
11 BASKET REPLACEMENT: Should the basket need to be
replaced, fasten it to the clips at the front (fig_a) and
button it to the rear (fig_b).
12 WHEEL REMOVAL: the stroller wheels may be removed.
To remove the front wheels, turn them to swivel
position, push the levers (fig_a) and simultaneously
push the wheel downwards until it is released (fig_b).
13 To remove the rear wheels, press the button (fig_a)
and at the same time push the wheels down until they
come off (fig_b).
14 FOLDING: before folding the stroller, close the hoods
(if attached). To fold the stroller, lift the buttons on the
sides of the handlebar (fig_a) and rotate the handlebar
forward until it clicks. Push the backrest and the hoods
towards the stroller and lower the handlebar until it
slots into its housing (fig_b). Ensure the stroller is fully
folded by checking the safety fastener (fig_c). The
stroller is freestanding when folded up.
15 TRANSPORT: thanks to the carrying handle,
transporting the folded stroller is very simple.
16 REMOVABLE LINING: to remove the stroller lining, first
remove the hoods, then the cover on the side (fig_a).
Push the pin upwards and then outwards (fig_b), and
finally slip it out of the eyelet in the sack (fig_c). Do this
on both sides and in the middle.
17 To detach the sack from the seat, remove the leg
divider strap from under the seat (fig_a), and unbutton
it (fig_b). Unscrew the safety harness from both sides
(fig_c) and slip the sack off the seat (fig_d).

ACCESSORIES

18 RAIN COVER: transparent rain cover for the Aria Twin
stroller.
19 CHANGING BAG: bag with pad for changing the baby.
Can be attached to the stroller.

SERIAL NUMBERS

20 ARIA TWIN reports information as at the date of
manufacture of the product.
_ Product name, date of manufacture and serial number
of the product.
This information is essential in the event of any
complaints.

CLEANING AND MAINTENANCE

PRODUCT MAINTENANCE: protect from the weather:
water, rain, or snow; prolonged and continuous
exposure to bright sunlight may give rise to colour
changes of various different materials; store this
product in a dry place.
CLEANING THE CHASSIS: periodically clean all plastic
parts with a damp cloth. Do not use solvent or
similar cleaning products; keep all metal parts dry to
prevent rusting; keep moving parts clean (adjustment
mechanisms, locking mechanisms, wheels, ...) and free
of dust and sand and, if necessary, lubricate with light
machine oil.
CLEANING THE RAIN CANOPY: wash with a sponge and
soapy water; do not use detergents.
CLEANING FABRIC PARTS: brush fabric parts to remove
dust and wash by hand at a maximum temperature of
30°C; do not wring; do not use chlorine bleach, do not
iron; do not dry clean; do not apply solvent-based stain
removers and do not dry in a tumble dryer.
PEG-PÉREGO S.p.A.
Peg-Pérego S.p.A. is an ISO 9001 certified
company. This certification is a guarantee
for customers and consumers of the
transparency and trustworthiness of the
company's procedures and working
methods.
Peg Pérego can make changes at any time to the
models described in this publication for technical or
commercial reasons.
Peg Pérego is at the disposal of its customers and
consumers to ensure that all their demands and
queries are fully satisfied. It is a key part of our policy
to ensure we are always aware of our customers'
views and requirements. We would therefore be very
grateful if, after using a Peg Pérego product, you
take the time to fill in our CUSTOMER SATISFACTION
QUESTIONNAIRE, making a note of any comments
or suggestions you might have. You can find the
questionnaire on the Peg Pérego website: www.
pegperego.com
PEG-PÉREGO AFTER-SALES SERVICE
If any parts of your Peg Pérego product should be
accidentally mislaid or damaged, use exclusively
genuine original Peg Pérego replacements. For any
repairs, replacements, product information, and orders
for genuine original replacement parts and accessories,
please contact Peg Perego After Sales Service
indicating the product serial number, if any.
tel. 0039/039/60.88.213
e-mail assistenza@pegperego.it
website www.pegperego.com
- 12 -
fax 0039/039/33.09.992