2.3 Installation of the keyboard
Recommended requirement for that is the successful installation of the USB receiver under point 2.2.
• If you have not yet removed the covering of the battery
case on the bottom of your keyboard, please do so now.
Insert the included batteries of type AAA 1.5 V
considering the right polarity in the battery case
(see picture).
• Switch the I/O sliding switch to ON position!
Advice:
The USB receiver and the keyboard are already factory-set to the same radio channel. Normally you do
not have to re-synchronise (as described under point 2.4). The keyboard is immediately functional.
• You can now check the functionality by pressing any
key of your keyboard. If you, for example, press the
Windows key, the Windows pop-up menu should open
up at the bottom left hand side of your screen. If so,
your wireless keyboard is working correctly now. If not,
please re-synchronise the USB receiver and the
keyboard like described under point 2.4.
Advise:
Should the functionality be influenced by other users applying their wireless keyboard close-by, make a
new-synchronisation as described under point 2.4.
Version 1.2 (2010/11/09) ● © 2010 by MaxPoint Handelsges. mbH
- 11 -