GeneralAire Water Savor GF-WSAVOR Instructions D'installation

Water Savor™ Controller Water Savor™ Controller
Installation Instructions
Read and Save These Instructions Read and Save These Instructions Read and Save These Instructions
I. Safety
 ! WARNING! Improper electrical wiring can result in fi re, failure, or loss of humidity control.
Disconnect electrical power before installing or servicing. Failure to disconnect electrical
power may result in injury or death. All local building and electrical codes must be followed.
Congratulations! You have decided to save money and the environment by installing the Water
Savor™ Controller. The Water Savor™ Controller is an electronic device that controls the amount of
water used by a ow-through by-pass humidi er; part of which would normally be wasted down the
drain.
The Water Savor™ Controller should be installed by a licensed technician. Failure to properly install
or operate the Water Savor™ may result in property damage, personal injury or humidity levels that are less than desired. Read instructions
carefully to safely achieve maximum humidity and water savings.
Safety questions regarding the Water Savor™ Controller may be directed to General Filters, Inc.
CANADIAN CUSTOMERS: (888) 216-9184; USA CUSTOMERS: (866) 476-5101.
II. Application:
When there is a call for humidity, the Water Savor™ Controller cycles 24vac of power to the humidi ers solenoid valve. Settings can be adjusted
1-6 (See Figure 3) to ensure that the humidi er will work at full capacity while also saving the maximum amount of water as possible.
III. Installation Instructions:
Precautions
:
WARNING: Disconnect electrical power before beginning installation. After installation is complete and before leaving, check to ensure the

!
humidi er is functioning as intended.
Mounting:
1. Chose a location for the Water Savor™. To prevent water damage, mount to the side or above the humidi er (See Figure 1). Never install
below the humidifi er. Some solenoid valve wires are long enough to connect directly to the Water Savor™. If not, additional wire may be
required.
2. Mount the Water Savor™ on the duct using the (2) #8 X 3/4 PHILLIPS HEX screws provided.
Figure 1
Wiring Instructions
(Wire is not included. 18 gage wire is recommended.)
3. Connect the two humidi er solenoid wires to the screw terminals labeled: "24VAC TO SOLENOID" (See Figure 2).
4. Connect the 24VAC power source wires (1 from humidistat & 1 from transformer) to the screw terminals labeled "24VAC IN" (See Figure 2).
IV. Recommended Water Savor™ Dip Switch Settings
1. Refer to the Recommended Dip Switch Settings Chart (Table; next page) to nd the Water
Savor™ setting that matches the applicable humidi er model.
2. Use a small at head screw driver to adjust the Water Savor™ to the applicalble setting
(See Figure 3).
1-6 settings (1 = maximum water savings; 6 = minimum water savings).
3. Only one setting should be ON at a time. (See Figure 3).
NEVER install below the humidifi er.
Mount to the side or above the unit.
Figure 2
:
Canada: GF-WSAVOR Canada: GF-WSAVOR
USA: GFI #7081
ON POSITION
OFF POSITION
Figure 3