XtremeMac SOMA SOUND WALL Mode D'emploi page 9

Turning the Soma™ Sound Wall On and Off
1. Turn on the unit by pressing the Power button v ;
a tone will sound and the LED will light red to
indicate the power is on, but not paired.
NOTE: If the unit has been paired previously and
the paired unit is close by, the LED will light blue to
indicate it has been paired.
2. Turn the unit off by pressing the Power button v
until the LED turns off.
Pairing a Bluetooth Device with the Speaker
1. Turn on the unit as described above.
2. Press and hold the Bluetooth button u for
approximately two seconds until the LED starts
blinking blue.
3. Within five minutes, select Soma Sound Wall
from the Bluetooth List on the external device.
See external device's owner's manual for details.
When paired successfully, the Sound Wall's LED
will light solid blue.
NOTE: If the unit is not paired within five minutes,
the LED will stop blinking.
4. Audio played through the external device will
now be heard through the Sound Wall speaker.
5. While in the audio app on your external
device, press the Play/Pause button w to play,
press again to pause and press yet again to
resume play.
Made in China | Fabriqué en Chine • Designed in the USA. © Imation Corp.
XtremeMac, Soma and the "X" logo are trademarks of Imation Corp. The Bluetooth ®
word mark and logos are registered trademarks owned by Bluetooth SIG, Inc. and
any use of such marks by Imation Corp. is under license. Distributed by Imation
Enterprises Corp., Oakdale, MN, USA.
9