Daspi TX NEW CLONER Manuel page 2

Frequencies below 433 MHZ are forbidden in Europe. They are only allowed in countries where they are authorized and don't
belong to the EU. Any handling or use of these frequencies are at buyer's responsibility.
In compliance with DIRECTIVE 2014/53/EU
MANUFACTURED BY /FAB: ESB06450563
ATTENTION: IN TX NEWCLONER (MULTICLONER) YOU CAN PROGRAMME A
DIRECT ENTRY MODE IN THE RECEIVER
PROGRAMMING INSTRUCTIONS
1. Locate the selector DIP inside the remote. Lever to separate the case
using the tab on lower side of the remote (see image below).
2. Select the DIP combination for the chosen brand. Go to table 1.
3. The remote is ready to be used. Please refer to your receiver's user
manual.
NOTE: To programme BFT, MUTANCODE and ERREKA it will be necessary to press the hidden button (with a
clip) before pressing any remote's button (button 1 to 4).
DS008 TX NEW CLONER
MANUAL TX NEW CLONER
HIDDEN
BUTTON
ATTENTION, THIS REMOTE WORKS IN TWO DIFFERENT MODES:
1. DIRECT ENTRY INTO THE RECEIVER
2. CLONE
FREQUENCY
IN EACH BUTTON (CHANNEL) ONLY IN
TECHNICAL FEATURES
ü Model TX NEWCLONER
ü 1 battery 2032(3V)
ü Frequencies 433,92 to 900 MHz
ü 4 Channels
ü Special chip
ü Software New Cloner patented
DIFFERENT BRAND AND
CLONE MODE
.